http://sop.mse.mtu.edu/index.php?action=history&feed=atom&title=Buehler_Vibrometer_I 2026-06-02T16:21:36Z Revision history for this page on the wiki MediaWiki 1.37.2 http://sop.mse.mtu.edu/index.php?title=Buehler_Vibrometer_I&diff=183&oldid=prev 2022-05-24T18:47:30Z

<p>Copied from old</p> <p><b>New page</b></p><div>[[Category: SOP]]<br /> <br /> =Saftey=<br /> ==Loss Prevention==<br /> ==PPE==<br /> <br /> =Procedure=<br /> ==Startup==<br /> #Check over the machine for unsafe conditions.<br /> #Check that the four bolts attaching the basin to the machine are snug and secure.<br /> #Check which basin you should be using. They should be labelled ductile iron or aluminum.<br /> #For aluminum use the colloidal solution and wet the pad, For iron, also wet the pad but then put about a ¼ inch layer of water on top.<br /> #NOTE: This machine is only meant to be used for the very final step of polishing. [[File:buehler_vibromet1.jpg|150px|thumb|right|Image {A}]]<br /> <br /> ==Mounts==<br /> #Place the mount into the proper sample holder using the recessed holes in the mounting device.{A,B}<br /> #Tighten the set screw only until the mount is firmly tight, not too far.<br /> #Carefully place the sample holder along the outer edge of the basin. {C}[[File:buehler_vibromet2.jpg|150px|thumb|right|Image {B}]]<br /> <br /> ==Operation==<br /> #After ensuring the vibration setting is set at 0, turn on the machine.<br /> #Slowly adjust the vibration until the sample holder makes a revolution approximately every ten seconds.<br /> #Wait 30-60 minutes, longer for harder materials. [[File:buehler_vibromet3.jpg|150px|thumb|right|Image {C}]]<br /> <br /> <br /> ==Shutdown==<br /> #Once stopped, remove sample holder with sample.<br /> #Place them both into the ultrasonic cleaner.<br /> #Remove mount from holder.<br /> #Remove basin assembly from machine by unscrewing the four hex head bolts. Immediately replace the bolts on the machine.<br /> #Wash the basin assembly under the sink. <br /> #Place in ziplock bag to maintain moisture.<br /> #Clean the work area. [[File:buehler_vibromet4.jpg|150px|thumb|right|Image {D}]]</div>

Gcanzalo