http://sop.mse.mtu.edu/index.php?action=history&feed=atom&title=Ductile_Iron_-_Hacksaw 2026-06-02T21:33:07Z Revision history for this page on the wiki MediaWiki 1.37.2 http://sop.mse.mtu.edu/index.php?title=Ductile_Iron_-_Hacksaw&diff=193&oldid=prev 2022-05-24T18:53:46Z

<p>Copied from old</p> <p><b>New page</b></p><div>[[Category: SOP]]<br /> <br /> This SOP describes the process of machining Section A from a one-inch y-block. This SOP references the ASTM A536 - 84 &quot;Standard Specification for Ductile Iron Castings&quot;.<br /> <br /> =Safety Concerns=<br /> * Ensure fingers and debris are clear from blade<br /> * Ensure sample is secure in clamps to prevent movement<br /> * Have necessary PPE safety glasses, green jacket, and steel-toed boots<br /> * Report any problems to [https://www.mtu.edu/materials/department/staff/ Russ Stein]<br /> <br /> =SSFDI Hacksaw Procedure=<br /> [[File:Hacksaw.JPG|thumb|alt=A Consumables.|right|upright=0.35]]<br /> [[File:Bedandclamps.JPG|thumb|alt=A Consumables.|right|upright=0.35]]<br /> [[File:Kill-Start.JPG|thumb|alt=A Consumables.|right|upright=0.35]]<br /> <br /> #Inspect blade and equipment before hand for any damage<br /> #Measure from the bottom of the y-block 1 1/8 inch<br /> #Position y-block horizontally and align blade to the measured position<br /> #Secure y-block with clamps<br /> #Position water hoses to aim at the y-block to give proper lubrication<br /> #Turn on hacksaw<br /> #Machine will automatic shut off when finished<br /> Pay attention, hit the kill switch if the machine doesn&#039;t stop to prevent the blade going into the bed</div>

Gcanzalo