Ductile Iron - Bandsaw

This SOP describes the process of machining Section A from a one-inch y-block. This SOP references the ASTM A536 - 84 "Standard Specification for Ductile Iron Castings".

Safety Concerns

• Ensure fingers and debris are clear from blade
• Ensure sample is secure in clamps to prevent movement
• Have necessary PPE safety glasses, green jacket, and steel-toed boots
• Report any problems to Russ Stein

SSFDI Bandsaw Procedure

1. Inspect blade and equipment before hand for any damage
2. Measure from the bottom of the y-block 1 1/8 inch
3. Position y-block horizontally and align blade to the measured position
4. Secure y-block with clamps
5. Position water hoses to aim at the y-block to give proper lubrication
6. Turn on hacksaw
7. Machine will automatic shut off when finished
8. Clean up debris and area